The Aviom Mix320-A Personal Mixing System includes everything you need to create a 16-input personal mixing system for six performers. It's perfect for stage or studio use.
Connect balanced analog inputs from a mixing console for live use or to the outputs of your DAW recording interface or console to create a studio cue system.
The A320 Personal Mixers get their digital data and power over the same cable, so all you need to do is connect a Cat-5 cable and you're ready to start using the system.
Aviom Mix320-A Features
- 16-input personal mixing system
- For Six performers
- Perfect for stage or studio use
- AN-16/i v.2 Input Module1
- D400 A-Net Distributor1
- A320 Personal Mixers6
- MT-1a Mic Stand Mounts6
- Cat-5e cables7
- A320 Specifications
- Audio Output: 1/4" TRS stereo, headphone or line level
- Stereo Mix Output, Headphone/Line
- Tip: Audio Left
- Ring: Audio Right
- Sleeve: Ground
- A-Net I/O
- 1 A-Net In, RJ45 connector
- Supports Pro16 and Pro16e
- D/A Conversion: 44.1/48kHz, 24-bit
- Stereo Operation
- Stereo Link, per channel pair
- Set at the input module
- Variable pan per mono channel or pan/spread per stereo channel pair
- Headphone Output: 275 mW per side into 50 Ohms (both sides driven)
- Output Impedance: 5 Ohms
- Freq. Response: 3Hz-22kHz +0.2dB/-3dB at 50 Ohms
- THD +N: < 0.003%
- Output Voltage for Personal Mixers
- 24VDC, 0.5 amp
- Transmitted over the Cat-5e cable
- Signal to Noise (unweighted): -106dB (measured with zero data into all channels)
- Latency: 0.880 msec (measured from analog input to analog output)
- Pro16e A-Net
- Use Cat-5e (or better) cable
- Maximum 400 ft (122 m) between devices
- Supports Power Over A-Net
- Cat-5 cable: Use shielded Cat-5e (or better) cable to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.
- Power
- 24 VDC, 0.5 amp
- Power is supplied over the Cat-5 cable when connected to an Aviom A-Net Distributor
- Dimensions (WxDxH): 10.26x6.14x1.91" (260.6x155.95x48.51 mm)
- Weight: 1.3 lb (0.59 kg)
- AN-16/i v.2 Specifications
- Audio Inputs: 16, balanced line-level, 1/4-inch TRS connector
- Inputs: Tip: Audio +; Ring: Audio -; Sleeve: Ground
- TRS Thru: Impedance matched output
- Analog to Digital Conversion: 48kHz sample rate, 24 bit
- Frequency Response: 4Hz-22kHz
- A- Net In
- One Category 5 (RJ45 connector)
- Four-position slot range selector switch for use with Pro16e A-Net
- A-Net Out: One Category 5 (RJ45 connector)
- Gain Settings: Four-position switch, -10dBv, 0dBu, +4dBu, and +22dBu
- Channel LED Indicators: Signal Present and Clip, per channel
- Line Inputs: Impedance: 48k ohms
- Metering: LEDs; green: Signal Present, red: Clip; per channel
- Stereo Operation
- Stereo Link, per channel pair
- Two-position switch (Normal, Link)
- Maximum Input Level: +22dBu
- Input Impedance: 17.8k ohm
- Freq. Response: 4Hz-22kHz +0.2dB/-3dB
- THD+N: < 0.003%
- Crosstalk: -90dB
- Bit Error Rate (BER): 10(-12)
- Signal to Noise (unweighted)
- 90dB typical, A/D to D/A
- Measured from AN-16/i to AN-16/o Output Module
- Digital Outputs: A-Net: 1; RJ45 connector
- Pro16e A-Net: Use unshielded Cat-5e UTP (or better) cable
- Latency: <0.880 msec (measured from analog input to analog output)
- Power Supply: External, DC, universal switching type
- Input Voltage: 100-240 volts, 50/60Hz, 30VA
- Output Voltage: 18-24 VDC, 0.5 amp
- Plug Size: 2 mm
- Power: 18-24 VDC, 500mA
- Dimensions: 19" (482.6 mm) wide x 5.75" (146 mm) deep; 1U high
- Weight: 6.8 lbs (3.08 kg)
- D400 Specifications
- A-Net Input
- Pro16 or Pro16e A-Net
- RJ45 connector
- A-Net Offset Base Slot: 2-position DIP switch selects the starting channel that Personal Mixers will receive from the network (1, 17, 33, or 49)
- Defeat Stereo Switches: Chooses between local (front panel) stereo links (up) or network stereo links (down)
- A-Net Out to Personal Mixers: Eight RJ45 connectors, powered
- A-Net Out
- Pro16e A-Net
- RJ45 connector, unpowered
- LEDs: Power On (red); Network Sync (green)
- Stereo Link: Two 8-position DIP switch blocks (1-16, 17-32)
- Output Voltage for Personal Mixers
- 24VDC, 0.5 amp
- Transmitted over the Cat-5e cable
- A-Net Cables: Front Panel Connections: Shielded Cat-5e (or better) cable must be used to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits. Unshielded Cat-5e cable may be used on all rear panel connections
- Power Supply: Internal, IEC connector
- Input Voltage: 100-120 VAC or 200-240 VAC (with selector switch); 50-60Hz @220 W max
- AC Fuse Types
- 115V range: T2.5AL/250V
- 230V range: T1.25AL/250V
- Dimensions: 19" (482.6 mm) wide x 7.386" (187.6 mm) deep; 2U, 3.5" (88.9 mm) high
- Weight: 12 lbs (5.44 kg)
- A-Net Input
