A complete Stereo Pair with two carefully factory-matched d:dicate ST4015A Wide Cardioid Microphones. Even though the standard tolerances on d:dicate™ series are extremely low, a stereo match is even closer. These mics are matched within ±1 dB on both frequency response and sensitivity.
DPA's wide cardioid microphones are capable of handling extremely high sound pressure levels before clipping occurs. The d:dicate 4015A Wide Cardioid Microphone even includes a 20 dB pad switch in the center of the XLR connector to prevent overloading of the mic amplifier.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of the microphone/accessory inlays.
DPA ST4015A Features
- Low profile - wide pickup area
- Natural reproduction
- Directional ambience pickup
- Carefully matched within ±1 dB
- Peli Case transportation and protection
- Modular flexibility
- 4015A wide cardioid microphones2
- Clips2
- Windscreens2
- Carry case1
- Transducer TypeCondenser
- Polar Patternwide cardioid
- Frequency Response20 Hz - 20 kHz
- Rated Output Impedance200 ohms
- Sensitivity, Nominal ±2 dB at 1kHz10 mV/Pa; -40 dB re. 1 V/Pa
- Equivalent Noise Level, A-Weightedtyp. 18 dB(A) re. 20 µPa (max. 20 dB(A))
- Equivalent Noise Level, ITU-R BS.468-4typ. 25 dB (max. 27 dB)
- Distortion, THD < 1%136 dB SPL RMS, 139 dB SPL peak
- Dynamic Rangetyp. 121 dB
- Max. SPL, THD 10%159 dB SPL peak
- Switchable Attenuator, Filters, etc.0 dB / -20 dB
- Cable Drive Capability100 m (328 ft)
- Output Balance PrincipleImpedance balancing with Active Drive
- CMRR> 60 dB
- Power Supply (for full performance)P48 (Phantom Power)
- Current Consumption2.8 mA
- ConnectorXLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Colormatte black
- Weight5.6 oz
- Dimensions0.75" diameter x 6.7" length
- Max. Output Voltage, RMS8 V
- Matching Tolerance (frequency response and sensitivity)±1 dB
- Phase Deviation for Kit< 10°
