Adjust your tools – take control
Boost your signal by switching to Active Mode - for ear-catching realism and distortion-free sonic depth.
Feedback-proof
The supercardioid polar pattern guarantees high gain before feedback. Even with more than half of the wire-mesh cup covered, it will not lose any rear or side rejection.
Low-cut and gain settings
Low-cut filters eliminate unwanted low-frequency sounds, compensate the proximity effect and reduce structure-borne noise. The built-in three-position switchable amplifier, is specially adapted to the MTP 840 DM’s components, allowing lossless recording of even far-off sources.
Maximum reliability
The outside enclosure of wire-mesh cup and ring is made of spring steel, while the body consists of zinc die-cast parts. The inner enclosure is made of resilient but lightweight nylon enforced-reinforced ABS. This design ensures the best possible protection for the rough daily touring routines.
Lowest handling noise
LEWITT’s internal dual shock mount system achieves the most efficient handling noise elimination. Refined rubber suspensions provide the best possible dampening of unwanted structure-borne noise caused by hand-movement.
Designed and engineered in Vienna, Austria
Like all LEWITT microphones, the MTP 840 DM is designed and engineered in Vienna, Austria
Microphone Features
- Dynamic vocal microphone
- Active mode to boost sensitivity
- Tailored vocal sound
- Low-cut settings
- Supercardioid pattern
- Transducer TypeDynamic
- Frequency Response40 - 18,000 Hz
- Polar PatternSupercardioid
- Output Impedance600 Ω
- Sensitivity3.5 mV/Pa, -49 dBV/Pa
- Connector3-Pin XLRM
- Net Weight381 g, 13.4 oz