
- Compatibility
- With Frequency Manager: Up to 11 compatible systems in typical setting, and up to 16 under ideal conditions
- Without Frequency Manager: Up to 4 compatible systems in typical setting, and up to 8 under ideal conditions
- System Operating Range
- Indoors: Up to 30 m (100 ft.) typical, with a maximum of 60 m (200 ft.) under ideal conditions
- Outdoors: Up to 20 m (65 ft.) typical, with a maximum of 50 m (165 ft.) under ideal conditions
- Transmit Mode Shure Proprietary Digital - Dual Band (2.4 GHz and 5.8 GHz)
- Audio Frequency Response 20 Hz – 20 kHz Note: Dependent on microphone type
- Dynamic Range 120 dB, A-weighted
- RF Sensitivity -88 dBm, typical
- Total Harmonic Distortion 0.07%, typical
- RF Output Power 10 mW E.I.R.P. max
- Operating Temperature Range -18°C (0°F) to 57°C (135°F) Note: Battery characteristics may limit this range.
- Storage Temperature Range -29°C (-20°F) to 74°C (165°F)
- PolarityPositive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low-impedance output) and the tip of the high impedance 6,35 mm output.
- Battery Life Up to 12 hours
- GLXD1+ DUAL BAND BODYPACK TRANSMITTER
- Dimensions (HxWxD) : 4.5x2.6x1.1” (115x66.94x28.51mm), without antenna
- Weight: 5.4 oz (153.1g), without battery
- Power Requirements: 3.7V Rechargeable Li-Ion
- Housing Cast: Metal, Black Powdercoat
- Input Impedance: 900 kΩ RF
- Output Power: 10 mW E.I.R.P. max
- TRANSMITTER INPUT
- Connector: 4-Pin male mini connector (TA4M)
- Configuration: Unbalanced
- Maximum Input Level (1 kHz at 1% THD): +8.4 dBV (7.5 Vp-p)
- Antenna Type: Dual Band Internal Monopole
- Pin Assignments TA4M
- 1: Ground (cable shield)
- 2: + 5 V Bias
- 3: Audio
- 4: Tied through active load to ground (On instrument adapter cable, pin 4 floats)
- GLXD4+ DUAL BAND WIRELESS RECEIVER
- Dimensions (HxWxD): 7.2x4.8x1.6" (182.8x121.97x40.3 mm), antennas folded
- Weight : 10.9 oz (310g)
- Housing : Molded Plastic
- Power Requirements : 14.5V - 17V, 600mA
- Spurious Rejection: >35 dB, typical
- Gain Adjustment Range: -20 to 40 dB in 1 dB steps
- Phantom Power Protection: Yes
- Configuration
- XLR Output: Impedance Balanced
- 6.35 mm (1/4“) output: Impedance Balanced
- Impedance
- XLR Output: 100Ω
- 6.35 mm (1/4“) output: 100Ω (50Ω, Unbalanced)
- Maximum Audio Output Level
- XLR connector (into 600 Ω load): 1dBV
- 6.35 mm (1/4“) connector (into 3 kΩ load): +8.5 dBV
- Pin Assignments
- XLR Output: 1=ground, 2=hot, 3=cold
- 6.35 mm (1/4“) connector: Tip=audio, Ring/Sleeve=ground
- RECEIVER ANTENNA INPUT
- Impedance 50Ω
- Antenna Type Dual Band 1/2 Wave Sleeve Dipole, non-removable
- Maximum Input Level −20 dBm
- SM31FH HEADWORN MICROPHONE
- Type: Electret Condenser
- Frequency Response: 45 Hz to 20,000 Hz
- Polar Pattern: Unidirectional (Cardioid)
- Output Impedance (@ 1 kHz): 600Ω
- Audio Output Level: -50.0 dBV/Pa
- Signal-To-Noise Ratio [1], @ 1 kHz: 66 dB
- Maximum SPL [1], 1000 Ω load, 1 kHz@ 3%THD: 145.0 dB
- Dynamic Range [1] @ 1 kHz, 1000Ω load: 117.0 dB
- Equivalent Output Noise [1] typical, A-Weighted: 28 dB
- Power Requirements: +5V DC (nominal), 10V maximum (DC bias)
- Polarity: Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1
- Cable: 45" (1.1m)
- Connector: TA4F
- Net Weight: 2.11 oz (60g)
- Notes
- [1] Measurements taken using RPM626 preamp set @ 0 dB using 8k bias resistor.
- *All specifications measured with a 48 Vdc phantom power supply. The microphone operates at lower voltages, but with slightly decreased headroom and sensitivity.
Why Choose SoundPro?
Since 1973, SoundPro has been the trusted source for audio, video, and lighting gear. Whether you're starting your AVL journey or are a seasoned professional, we're here to help you every step of the way.