The front panel of the D-RC2ST features two pushbuttons with two associated LEDs. Upon initial power-up, source 1 is selected. Touching the other button de-selects source 1 and immediately selects source 2. An LED adjacent to each button shows which source is selected.
In a typical installation, the D-RC2ST may be used to select between two audio or video sources, or to route audio to two destinations. To select between two audio sources, the D-RC2ST is connected to an RDL ST-SSR1 Solid-State Audio Switch. For video switching, an RDL TX-MVX may be used. For audio routing, an RDL ST-RX2 is used. In each of the above examples, only one output terminal is needed for triggering. Therefore a single shielded pair (or 3-conductor cable) is required for remote connection. For more complex switching networks, both outputs may be used.
RDL D-RC2ST Features
- Remote Selection of 2 Audio Sources, Destinations or Functions
- Single-Button Selection for Each Source
- Open-collector Switching of 1 of 2 Module Functions
- 3-wire or 4-wire Remote Wiring
- Professional Aesthetic Appearance
- Companion to other RDL® Remote Controls
- D-RC2ST 2-Channel Remote Control for STICK-ON1
- Selectors (2)Momentary pushbuttons, (1 for each channel)
- Indicators (2)Red LEDs, (indicates channel selected)
- ConnectionsDetachable terminal block; Power input; open-collector outputs (25 mA current limited)
- Ambient Operating Environment-10° C to 55° C
- Power RequirementGROUND-REFERENCED, 24 Vdc @ 30 mA
- MountingMounts in standard US electrical box, RDL WB- or SMB- series boxes; cover plate available separately
- Package Dimensions3.625 x 4.625 x 2.125 in.
- Shipping Weight365 lbs.
- WEEE weight0.215 lbs.
