The Aviom Mix320-D Personal Mixing System has been designed specifically for use with Dante™ enabled mixing consoles and networks. It includes everything you need to create a personal mixing system for six performers.
The A320 Personal Mixers get their digital data and power over the same cable, so all you need to do is connect a Cat-5 cable and you're ready to start using the system.
Aviom Mix320-D Features
- Personal Mixing System
- Designed specifically for use with Dante™ enabled mixing consoles and networks
- Everything you need to create a personal mixing system for six performers
- D400-Dante A-Net Distributor1
- A320 Personal Mixers6
- MT-1a Mic Stand Mounts6
- Cat-5e cables7
- A320 Specifications
- Audio Output: 1/4" TRS stereo, headphone or line level
- Stereo Mix Output, Headphone/Line
- Tip: Audio Left
- Ring: Audio Right
- Sleeve: Ground
- A-Net I/O
- 1 A-Net In, RJ45 connector
- Supports Pro16 and Pro16e
- D/A Conversion: 44.1/48kHz, 24-bit
- Stereo Operation
- Stereo Link, per channel pair
- Set at the input module
- Variable pan per mono channel or pan/spread per stereo channel pair
- Headphone Output: 275 mW per side into 50 Ohms (both sides driven)
- Output Impedance: 5 Ohms
- Freq. Response: 3Hz-22kHz +0.2dB/-3dB at 50 Ohms
- THD +N: < 0.003%
- Output Voltage for Personal Mixers
- 24VDC, 0.5 amp
- Transmitted over the Cat-5e cable
- Signal to Noise (unweighted): -106dB (measured with zero data into all channels)
- Latency: 0.880 msec (measured from analog input to analog output)
- Pro16e A-Net
- Use Cat-5e (or better) cable
- Maximum 400 ft (122 m) between devices
- Supports Power Over A-Net
- Cat-5 cable: Use shielded Cat-5e (or better) cable to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.
- Power
- 24 VDC, 0.5 amp
- Power is supplied over the Cat-5 cable when connected to an Aviom A-Net Distributor
- Dimensions (WxDxH): 10.26x6.14x1.91" (260.6x155.95x48.51 mm)
- Weight: 1.3 lb (0.59 kg)
- D400-Dante Specifications
- Dante Interface: 32 channels (44.1/48kHz Sample Rate)
- Dante Primary I/O: RJ45 connector
- Dante Secondary I/O: RJ45 connector
- Dante LEDs
- Network Activity (green)
- 1GB Network Connection Active (yellow)
- A-Net Out to Personal Mixers: Eight RJ45 connectors, powered
- A-Net Out
- Pro16e A-Net
- RJ45 connector, unpowered
- LEDs: Power On (red); Network Sync (green)
- Stereo Link: Two 8-position DIP switch blocks (1-16, 17-32)
- Output Voltage for Personal Mixers
- 24VDC, 0.5 amp
- Transmitted over the Cat-5e cable
- A-Net Cables
- Front Panel Connections: Shielded Cat-5e (or better) cable must be used to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.
- Unshielded Cat-5e cable may be used on all rear panel connections
- Power Supply: Internal, IEC connector
- Input Voltage: 100-120 VAC or 200-240 VAC (with selector switch); 50-60Hz @220 W max
- AC Fuse Types
- 115V range: T2.5AL/250V
- 230V range: T1.25AL/250V
- Dimensions: 19" (482.6 mm) wide x 7.386" (187.6 mm) deep; 2U, 3.5" (88.9 mm) high
- Weight: 12 lbs (5.44 kg)
